Hangzhou Grand Trading Co.,Ltd
+86-571-89006178, +86-571-89005733

Products

Knowledge
Home > Knowledge > Content

V-Belt Problems And Solutions In Use II

Source: | Updated: Dec 22, 2016

              

V-Belt Problems And Solutions In Use II

    

Problem The possible   reasons Solution
V belt was significantly elongated Center   distance changes or fluctuations Adjust   the tension, to design the   transmission
Excessive load Check   the rated power, change of V belt
Pulley has serious wear and tear Check   and replace the pulley
The pulley diameter less than the recommended   minimum value Increase   the diameter, using the correct pulley diameter
The temperature too high or too low Eliminate   or control the environment factors
Run in the solvent or corrosive conditions Eliminate   or control the environment factors
V belt running too fast Adjust the speed, redesign transmission
V belt use time is too long, more than life Replace   the V belt
At the bottom of   the V belt Do   not conform to the tension pulley position and size Increase   the pulley diameter
fracture or fracture Pulley   diameter is too short Increase   the diameter, using the correct pulley diameter
The environment temperature is too high To   eliminate or blocking the heat source, improve ventilation, change   environment
The environment temperature is too low Before   running the proper heating, change the environment
V belt bottom has excessive use Check   and adjust the pulley



Feedback
Contact Us
Address: No.22 Zhuwushan ,Huanghu Town,Yuhang district, Hangzhou City, Zhejiang Province, China
Tel: +86-571-89006178, +86-571-89005733
Fax: +86-571-88515928
E-mail:may@grandvbelt.com
Home | About Us | Products | Feedback | News | Knowledge | Contact Us | Mobile | XML